Frankie Muniz Racinglong, cut from stiff cardboard. Cut eyes, mouths and noses from colored paper to glue onto the balloon and add any other details with craft pens. Paint feet onto the cardboard, with the toes pointing towards the rounded edges. Make a small slit towards the pointy end of the heart and push the knotted end of the balloon through. Glue a coin onto each foot to weigh it down if the balloon person doesn't stand up. Cake M onsters Provide children with tubs of cookie dough and have them form "cookie monsters" by squidging lumps of dough into monstrous head and free templates body shapes. Older children may want to roll out their dough and cut out more accurate monster shapes. Place a sheet of baking paper on a tr ay and write each child's name beside their dough-monster. When cooked decorate with frosting and colored shakes, then play monster games un Frankie Muniz Racing til they've all been eaten. Who Am I Write a famous person's name on a post it note and stick it to the forehead of each child where they ca . a 5-inch, 12-inch and 18-inch lengths with hacksaw. 2 Grind or file corners of all four channels so they are not sharp. 3 Lay scissor lift l engthwise on bottom of 18-inch channel. Lips of channel will be down. Weld jack to channel iron. 4 Measure three inches from end of 12-inch channel. Mark five spots on center of lips spaced one inch apart. 5 Drill 11/16-inch holes at these spots through both lips with drill press . Repeat process on 15-inch channel. Test 5/8-inch bolt to make sure it will fit through holes. Adjust holes as required. 6 Align and center cgtextures 15-inch channel perpendicular to base of jack channel and weld with lips up. End with holes will be away from jack. This assembly will look like a T. 7 Set 12-inch channel with lips down. Weld 5-inch channel vertically at the end opposite the holes in the 12-inch piece. Lips fac Frankie Muniz Racing e toward holes. 8 Weld 5/8-inch bolt to top center of 15-inch channel near the end of channel. Weld 3-inch rod to 5/8-inch nut. Mask bolt th . rdseed. Stuff the bag into the leg and sew the other end shut. 11 Place the bag on top of the jack. Secure it with wire ties. 12 Cut, fit an d glue mouse pad to inside of 5-inch channel to protect rifle butt. 13 Set up lead sled by placing bolts through appropriate holes on channe ls depending on length of gun. 14 Use carpet pieces under rear channel for elevation and to avoid marring shooting bench. Do the same under jack channel. 15 Place barbell weights on 5/8-inch bolt and tighten with 5/8-inch nut handle that you made. 16 Set gun in place. Secure the iphone models gun to the front of the bag with plastic wire ties if you wish. Adjust scissors lift for elevation.Blind Fold Throw Divide the children into pairs, provide them with a soft ball and blindfold one child in each pair. The seeing children have to lead their blindfolded partner to an Frankie Muniz Racing other blindfolded child and direct them to throw the ball at their blindfolded opposite. That child's seeing partner should direct them to h .
|