Frankie Muniz Racingards. The person who slaps first is the winner and places the entire stack underneath his own stack. Play continues until only one player is left with cards. My Boat Docks This game is more fun when played at very high speed, but can be slowed down to accommodate very young begin ner players. Each player is dealt seven cards, and the rest of deck can be set aside. The object of the game is to collect seven cards from the same suit. Players decide in their heads which suit they would like to collect, but this can change as the game progresses. On cue, play free books ers slide an unwanted card to the player on their right. This is best done in a rhythm with all players discarding, sliding and picking up a t the same time. Do not allow a lot of time after sliding to decide which card to get rid of, and begin the slide process again. The play co Frankie Muniz Racing ntinues until one player shouts "My boat docks," meaning they have collected seven cards of the same suit.1 Wipe the tip of the soldering ir . oldering iron should be on and heated for this type of cleaning. Place the tip of the soldering iron in the cleaner. There will be smoke, so be prepared for that. This isn't necessary for light cleaning, but if the tip is very dirty, you will need this cleaning material. 3 Coat o r tin the tip of the soldering iron once you've finished cleaning off all of the old solder. Unroll a piece of solder and heat the iron. Rol l the tip of the soldering iron on the solder until a thin layer of it is on the tip. This might seem counterproductive since you just clean free websites ed it, but a thin layer of solder will protect the tip of the soldering iron from oxidation and corrosion.Cleanliness Cleanliness is extreme ly important for successful soldering, since the solder does not like to adhere to a dusty, dirty, oily, rusted or otherwise oxidized surfac Frankie Muniz Racing e. Even touching the metal prior to soldering will prevent the solder from sticking to it. Prior to making your repairs, clean everything th . nt factor in the success of your soldered joint. Secure your project in either a vise or frame, depending on the type of project you are wor king on. Circuit and breadboards can be secured in frames specifically made for the purpose. A modeler's vise can be used to hold wires in p lace. If there is movement during soldering, your joint may be compromised. When possible, twist wires together tightly prior to applying th e solder for the best possible connection. When attaching components to boards, insert the wires through the board and bend them flush to th paper texture e back of the board before soldering. Solder Use the proper solder -- one with a rosin core. Lead solder was common at one time, but it has now been replaced by lead-free solder because it is non-toxic. The rosin allows the solder to be free flowing when melted, and makes for smo Frankie Muniz Racing oth, even joints. Do not inhale the fumes of the solder when it is heated, and wash your hands after handling it. Technique Remember not to .
|