Frankie Muniz Racingve the cover from the SPDT switch using a screwdriver. Locate the two terminal blocks. One has three terminals, the other four. The three te rminals connect to the wire from the plug while the four terminals connect to the motor. 4 Loosen the screws on the three pin terminal block using a screwdriver. Connect the green stripped wire from the plug to the terminal labeled "Gnd" or "T" and tighten the screw. Connect the white/gray wire to the terminal labeled "Neu" and then the red/orange or black wire to the terminal labeled "Hot" or "Com." 5 Cut four strip tree texture s of AWG 16-gauge wire long enough to reach between the SPDT switch and the motor. Label the strips "A" through "D" using a marker pen. Remo ve ? inch of plastic off the ends of the four wire strips. 6 Loosen the four screws on the screws on the four pin terminal block. Connect th Frankie Muniz Racing e wire labeled "A" to the terminal labeled "A" or "1" and tighten the screw. Connect the wire labeled "B" to the terminal labeled "B" or "2" . Connect the opposite end of the wire labeled "D" to the terminal labeled "Com", "Hot" or "Pos" on the motor. Connect the opposite end of the wire labeled "A" to the terminal labeled "Slow," "Low" or similar. Connect the opposite of the wire labeled "B" to the remaining terminal. 8 Replace the cover on the SPDT switch and tighten the screw to hold the cover in place. Ensure the switch is in the "off" position. Insert the plug into the wall socket. Turn on the switch to the first position and the motor turns slowly. Move the switch to the second position a Cookie Diet nd the motor turns fast.1 Remove all rings, bracelets, necklaces or any other accessories that could get caught in the spin of the lathe. Th ese items can lead to extremely serious injuries if you are not careful. Always wear protective goggles and work gloves when using your lath Frankie Muniz Racing e to protect yourself from splintering or other forms of injury. 2 Lubricate the joints and bearings of the chuck or spinning mechanism. Pro . the grip firmly, ensuring that it is as centered as possible. If the grip is too loose, the wood may wobble or begin to move sideways during spin. This can lead to much more serious problems if the weighting becomes uneven, which can cause the material to fly off the lathe or spl inter in half. 5 Power on your lathe by flipping the power switch located above the motor drive belt near the engine. 6 Cut using light pres sure. The less force you use with your chisels and cutting tools, the smoother your cuts will be. Excessive force can push the material off car icon balance, cause the chuck to bind up and lead to sloppy detailing.Failings Hook J bolts can fail in a number of ways. They may have been poor ly machined and not fit the bolt hole they are rated for. The J bend may fissure or the threading on the opposite end of the J bend may brea Frankie Muniz Racing k or strip. They may also rust. Repairs A J bolt that is too large for a bolt hole may be sanded down to reduce its diameter. A rusted J bol .
|