Frankie Muniz Racinghe game will get a little loud. It is not necessary to make sure they keep quiet. In fact, this makes the teamwork even more necessary since the guide needs to communicate louder and the course walker must tune out the noise around him. Flipping the Tarp This is a good game to en courage teamwork as a whole group and not just two or three people. You will want to prepare this ahead of time even though there is very li ttle prep work. Simply lay a tarp on the floor of a gym or outside, depending on where you have your group of kids get together. Have all of free ebooks to download the kids stand on the tarp. The purpose of this game is to turn the tarp over completely without stepping on the floor or the ground. This game requires a lot of group teamwork as the tarp gets smaller. The group will have to figure out how to get one person at a time onto the b Frankie Muniz Racing ack side of the tarp. If you want to make this fairly difficult, use a relatively small tarp. The smaller the tarp, the more teamwork requir . he throttle stick (located on the left side of the controller) forward. The rotors will start to spin and the helicopter will rise and hover . Do not push the throttle forward too quickly, since that could cause the helicopter to spin out of control. 3 Adjust the throttle as neces sary to keep the helicopter hovering a few inches above the surface you took off from. You may need to give the engine less or more power to keep the helicopter from falling to the ground or climbing too high, respectively. Gently make any necessary adjustments. 4 Move the thrott football template le stick left or right to control the rudders and turn the helicopter in the desired direction. Press the stick on the right side of the con troller to move the ailerons -- the flaps on the helicopter that control the helicopter body's tilt. Pressing the stick forward will tilt th Frankie Muniz Racing e nose of the helicopter down, while pulling back will tilt it up. 5 Gently move the stick that controls the ailerons forward to tilt the he . to see how many square inches of metal it is capable of holding. There will be measurement marks on the work surface on which the metal is held. 2 Put on your safety glasses. Metal shards can fly in random directions during the metal carving process. 3 Place your piece of metal on the square surface containing the measurement marks on the front side of the gear shaper machine. Slide the clamps on either side of the surface over the piece of metal. 4 Bring the cutting tool of the gear shaper downward so that it is lightly touching the metal by pulling th sky texture e downfeeder in a downward direction. The downfeeder is a lever located at the upper front side of the machine. 5 Release the clutch of the gear shaper to begin the back and forth motion of the cutting tool. Pull the clutch lever on the side of the machine downward. 6 Control whe Frankie Muniz Racing re the cutting tool will carve the metal by moving the downfeed lever up and down with your hand. Pull the downfeed lever downward when the .
|