Frankie Muniz Racinge 12-inch wires to this column. Connect its free end to the 12-volt power supply's ground terminal. 4 Connect another 12-inch wire to the po wer supply's positive terminal. Insert its other end at pin 8. Connect the cathode lead of the diode to transistor's collector and the anode end to pin 4. Cut and strip a short jumper wire, and use it to connect pin 4 to the column with the 12-volt supply ground wire. 5 Insert th e two remaining 12-inch wires at pins 2 and 3. 6 Turn the power supply on. Twist the end of the wire at pin 2 around one lead of the 10K-ohm rental application form resistor. Touch the other lead repeatedly to the positive power supply terminal. You should hear the relay click as the wire gets the posit ive voltage.1 Cut a 3/4-inch hole into the top of the PVC cap with the power drill. Insert the 3/4-inch valve into the hole in the cap. Plac Frankie Muniz Racing e a nut onto the threads on the valve and tighten with the socket wrench. 2 Drill a 3/4-inch hole into the side of the PVC pipe 3 inches fro . PVC pipe and position the cap over the top. Apply PVC glue to the inside of the pipe and the outside edge of the cap. Press the cap onto the pipe and wait at least 4 minutes for the glue to dry. 5 Attach the middle section of the copper tee pipe to the valve on top of the cap. Ti ghten the pipe by turning it clockwise with the adjustable wrench. 6 Attach the shut-off valve to one end of the copper tee pipe. Solder the shut-off valve to the pipe using a soldering iron or tighten the fitting the with the adjustable wrench. 7 Place the open end of the PVC pi download books online pe in a bucket of water. Attach an air hose from a compressor or hand pump to the open end of the copper tee pipe. 8 Close the shut-off valv e and then turn on the compressor or pump the hand pump to begin inflating the rubber bladder. Add a couple of pounds of air pressure to the Frankie Muniz Racing rubber bladder. 9 Stop pumping or turn off the air compressor. Open the shut-off valve and the rubber bladder will begin to decompress. Whe . ty undercoat. Rubberized overcoat spray is also available at auto body stores. It is used to coat the bed of pickup trucks and is very water resistant. 2 Prepare the area around the rail. Sand and scrape any old peeling paint. If the paint peels off easily, plan to scrape and rep aint the entire hull. It is not recommended that you use a power sander. It will leave the area too flat and smooth. The paint will not stic k well to the flat surface. 3 Tape around the area of the hull you are not planning to cover. The rub rail will reach from the very rim of t free website he boat to about 6 inches from the rim. 4 Spray one coat of primer and allow this to dry for the manufacturer's recommended amount of time. 5 Spray two coats of undercoat spray. Allow time to dry between each coat.1 Remove the wire from the power source before wiring the two-stag Frankie Muniz Racing e electric motor. Cut the wire into two sections using a knife. Cut the wire where you intend to install the switch. 2 Strip off 2 inches of .
|