Frankie Muniz Racingsets. Start with the shortest components first and move gradually to the tallest ones. 2 Make any modifications for added features. You may have to acquire extra components at this stage. Internet forums are a great resource for questions regarding modifications to do-it-yoursel f circuits. 3 Connect knobs, levers and other control components to the project enclosure. Drill or cut holes if necessary. Wire the control s to the PCB. Solder each wire onto the PCB, then onto the control component. Try to avoid creating a tangle of wires. One possibility is to free book online bind groups of wire together with plastic pull ties. 4 Mount the antenna in the enclosure. Solder the leads onto the PCB. 5 Wire the batter y holder leads to the power connections of the PCB and solder them in place. 6 Mount the PCB in place in the enclosure with the proper screw Frankie Muniz Racing s. 7 Close the enclosure and screw the sections in place.1 Park the trailer on a flat surface. Preferably concrete, as jack stands can embed . upports the trailer's weight. Remove the car jack. 4 Remove the wheel nuts and the rim and tire. Pry the grease cap off the end of the axle with a slotted screwdriver. 5 Remove the pin which secures the castle nut and unscrew with a wrench. 6 Pull the hub off the spindle and clea n the spindle with a rag. Inspect it for any damage to its surface such as grooving or pitting. Replace, as necessary. 7 Apply grease to the inside of the new hub/bearing assembly and slide onto the spindle. Fasten the castle nut until it's tight, then back off the nut until the free html website templates first castellation lines up with the cotter pin key hole. Insert the cotter pin to lock the castle nut in place. 8 Grease the hub by connect ing a grease gun to the nipple on the end of the spindle. Fill with grease until it starts to come out the sides. 9 Repeat this process for Frankie Muniz Racing the other side of the trailer's hub.1 Hold the speed controller so that the side of it with three white wires and corresponding sockets is n . (negative) wires match those on the speed controller. The red end of the battery has a plug and the red end of the controller has a socket. Gently, but firmly, push them together until you hear a click. The black ends are the opposite: the controller has a plug and the battery h as the socket. Push them together, just like the red wires. 3 Move the receiver around until the throttle channel faces the speed controller . The controller has one square-shaped plug that is on the same side as the battery connectors. Push this plug into the throttle channel unt ice texture il it clicks into place.1 Place the propeller on the back plate and line them up so that the bolt slides through the center. Thread the nut on to the bolt and tighten it by hand. This will hold the propeller solidly in place while you measure it. 2 Use the ruler to measure the si Frankie Muniz Racing ze of the propeller from the top (outside face) down. Transfer the main shape and size to the piece of paper, sketching them out with the pe .
|