Frankie Muniz Racingcan get the spike to red heat, that will produce the best results. If not, you can still make your tomahawk -- you will just have to hammer longer. 2 Remove the spike from the forge using the tongs and place it on the anvil. To make a throwing tomahawk, hammer the spiked end fla t. It will take a narrow, rounded shape. For a chopping tomahawk, hammer and shape the head of the spike. This will allow you to flare the b it out fully and create a large, chopping edge. Hammer the edge thin enough so you can easily sharpen it. 3 Return the spike to the forge. Y css templates ou want to heat it most at the spot where you will make the eye to insert the handle. 4 Return the spike to the anvil. Use the metal chisel or bore and hammer to pound out the eye where you will insert the handle. Make the eye large enough to fit the narrow end of the handle comp Frankie Muniz Racing letely into it. Secure the handle by hammering the spike flat around it until it is tightly fitted.1 Place a sheet of newspaper on a work su . et them aside for later use. 3 Purchase a Testors-brand F-18 model kit -- the scale model size should be twice that of the Polar Lights movi e Batmobile that you are going to be converting. Remove the jet engine exhaust pipe from the kit and set it aside for later use. 4 Remove th e top shell of the Polar Lights movie Batmobile model based on the first motion picture from the kit. Place the top shell on the newspaper w ith the hood facing right. 5 Place the two dome sections on the top shell, just behind the hood. Trace the bottom of the two dome sections o wood background n the top shell with a grease pencil. Place the two dome sections aside. 6 Measure the width and depth of the Batman and Robin figures taken from the Polar Lights Batmobile snap-together kit model . Draw a square behind the two trace marks on the top shell that match the dimensio Frankie Muniz Racing ns measured; the measurement for the Batman figure being on the side of the top shell farthest from you and the measurements for the Robin f . ctions provided with the kit. Let the glue set for at least 3 hours before painting the model. Use a picture of the Batmobile from the TV sh ow as seen on the Web to guide you on how you should paint the model. 9 Paint the jet engine exhaust pipe the color to match the Batmobile f rom the TV show. Glue the jet engine exhaust pipe, once the paint has dried, to the back center edge of the Batmobile. Let the glue set for 10 minutes before continuing. 10 Place a set of dome sections on the top of the Batmobile, just in front of the holes that have been cut. Ro imac models tate the dome sections so that the curved sides face towards the hood. Lift the dome sections, apply glue to the bottoms and place them back on the top shell. Let the glue set for 10 minutes. 11 Apply glue to the bottom of the two other dome sections. Place them on the side of th Frankie Muniz Racing e holes facing the trunk, with the curved sections facing away from the hood. Let the glue set for 10 minutes. 12 Rotate the Batmobile so th .
|